20ft UN T14 Phosphor Tank Container
20ft UN T14 Phosphor Tank Container Introduction
The Phosphor Tank container is designed to comply with the requirements of IMDG Code, aiming at transportation and stock yellow Phosphor and phosphoric acid solution. This Phosphor Tank is made of stainless steel or carbon steel with lining and fitted with heated insulation system.
All tanks are of the highest quality design and construction and conform strictly to the latest international approvals.
20ft UN T14 Phosphor Tank Container Specification
| Ext. Length | 6,058mm |
| Ext. Height | 2,591mm |
| Ext. Width | 2,438mm |
| Tare | 4,500Kgs |
| M.G.W. | 30,480Kgs |
| Max. Payload | 25,980Kgs |
| Cubic Capacity | 17.5m³ |
| Max. Design Pressure | 2.65bar |
| Testing Pressure | 4.0bar |
| Tank Body Dia. | 2,000mm |
| Manhole Dia. | 450mm |
| Tank Design Standard | ASME-VIII-1&GB150-98 |
| Design Operating Temp. | -20 ~ +120°C |
| Tank Body Material | 1Cr18Ni9Ti/ 316L/ 316 or carbon steel with lining |
| Tank Body Thickness | 6.0mm |
| Stacking | 192,000kgs |
| Facilities | |
| Roof Discharging Valve | DN80 ball valve |
| Charging Valve | DN50 ball valve |
| N 2 Outlet Valve | 1.5″ ball valve |
| Pressure Relief Valve | 2.5″ relief valve, pressure /vacuum |
| N 2 Inlet Valve | 1.5″ ball valve |
| Charging Inlet Dia. | 250mm on top manhole |
| Thermograph | Thermocouple Thermograph 0~120 °C |
| Heating System | |
| Design Pressure | 4.0bar |
| Testing Pressure | 6.0bar |
| Seam Inlet/Outlet | 3/ 4″ with cover |
| Heating Area | 7.5mm2 |
| Thermal Insulation Layer | 50mmthick rock-wool covered with 0.8mm thick zinc-plated plate or stainless steel plate |
Please note that the above specifications are “general specifications” that pertain to the majority of our products. These specifications should only be used for general, informational purposes. The measurement/size of the goods delivered may be different from the data in the above table, please check with us when order placed.
Reviews
There are no reviews yet.